Anti-Kickback Pawls - MasterCraft 055-6755-8 Instruction Manual

20
model no. 055-6755-8 | contact us 1-800-689-9928
27
26
25
24
23
22
21
19
18
17
16
1 2
20
No. Description
1 Blade guard
3
2 Riving knife
3

Anti-kickback pawls

4
4 Right extension table
5
5 Sub fence
6
6 Rip fence storage
7
7 Push stick
8 Rip fence lock handle
8
9 Stand
9 10 Rubber foot
11 Bevel locking lever
12 Work table
10
13 Anti-kickback pawls storage
14 Blade wrench
Anti-kickback pawls:
11
Kickback is a hazard in which the workpiece is thrown back toward the operator. The teeth on the
anti-kickback pawls point away from the workpiece. If the workpiece should be pulled back toward the
operator, the teeth dig into the wood to help prevent or reduce the possibility of kickback.
Bevel scale and bevel indicator:
12
The easy-to-read scale and indicator on the front of the cabinet shows the exact blade angle.
13
Saw blade:
14
For maximum performance, it is recommended that you use the 24-tooth, 10" (25.4 cm) carbide-tipped
combination blade provided with your saw. The blade is raised and lowered with the height/bevel adjusting
handwheel. Bevel angles are locked with the bevel locking lever.
15
WARNING!
• Use only 10" (25.4 cm) diameter blades rated at maximum safe operating speeds of
4700 RPM or higher. Failure to heed this warning could result in personal injury.
• The blades should always be kept sharp. Use a reputable sharpening service to sharpen
the blades when needed.
• Never store the blades stacked on top of one another. Place material such as cardboard
between them to keep the blades from coming into contact with one another.
No. Description
15 Plug cable
16 Dust extraction port
17 Blade guard storage
18 Table insert
18 Rip fence
20 Saw blade
21 Bevel scale
22 Height-adjustment knob
23 Height/bevel adjusting handwheel
24 On/Off switch
25 Overload reset switch
26 Front rail
27 Mitre gauge
21