Table of Contents
Advertisement
28
model no. 055-6755-8 | contact us 1-800-689-9928
No.
Description
Screw M6 x 12 with flat washers 6,
7
spring washers 6 and hex nuts M6
TOOLS NEEDED FOR ASSEMBLY
Screwdriver
Star-head screwdriver
Wrench
UNPACKING
Do not use this product if any parts of the package contents are already assembled to your product when you
unpack it. Package contents are not assembled to the product by the manufacturer and require customer
installation. Use of a product that may have been improperly assembled could result in serious personal injury.
•
Carefully remove the table saw from the carton and remove the protective polyfoam around the motor.
•
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
•
Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
•
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures explained in this manual.
•
If any parts are damaged or missing, please call 1-800-689-9928 for assistance.
WARNING!
If any parts are damaged or missing, do not operate this tool until the parts are replaced. Use of
this product with damaged or missing parts could result in serious personal injury.
• Do not attempt to modify this tool or create accessories not recommended for use with this tool.
Any such alteration or modification is misuse and could result in a hazardous condition leading
to possible serious personal injury.
• Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
• Risk of injury! Always pull out the mains plug (disconnect the product from its power supply)
before commencing work on the product.
Qty.
Illustration
16
Framing square
Triangle square
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface such as a workbench or leg stand. Four bolt
holes have been provided in the saw's frame for this purpose.
To mount the saw to a work bench, insert bolts that are of suffcient length to accommodate the saw base,
lock washers, hex nuts, and the thickness of the workbench or other mounting surface. Tighten all bolts or
screws securely.
Carefully check the workbench after mounting to make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
To mount the saw to the leg stand, refer to specific procedures explained later in this section.
ASSEMBLE THE LEG STAND (Fig.2a-2k)
•
Attach one long top leg bracket stamped B (1) to the
top of one stand leg stamped A (2) using a screw
M6 x12 (3), flat washer 6 (4), spring washer 6 (5) and
hex nut M6 (6).
Make sure that the locking pins (7) on the stand leg
are secure in the holes (8) on leg bracket.
•
Attach other end of the long top leg bracket stamped
B (1) to top of the other stand leg stamped A (2) using
a screw M6 x12 (3), flat washer 6 (4), spring washer 6
(5) and hex nut M6 (6).
Make sure that the locking pins (7) on the stand leg
are secure in the holes (8) on leg bracket.
3
7
1
A
2
8
4
5
6
Fig. 2a
3
1
7
B
A
5
2
8
4
6
Fig. 2b
29
Hide quick links:
Advertisement
Table of Contents
