MasterCraft 055-6755-8 Instruction Manual page 16

30
model no. 055-6755-8 | contact us 1-800-689-9928
• Attach one long bottom leg bracket stamped C (9) to
the centre of each stand leg (2) using a screw M6 x12
(3), flat washer 6 (4), spring washer 6 (5) and hex nut
M6 (6). This completes the rear frame section.
Make sure that the locking pins (7) on the stand leg
are secure in the holes (8) on leg brackets.
• Assemble the front frame section by exactly repeating
above steps.
2
9
7
3
5
8
4
6
2
3
4
C
6
8
9
5
Fig. 2c
B
A
1
2
A
9
2
C
4
3
6
5
Fig. 2d
• Attach one end of the short top leg bracket stamped D
(10) to the rear frame assembly using a screw M6 x12
(3), flat washer 6 (4), spring washer 6 (5) and hex nut
M6 (6).
Make sure that the locking pins (7) on the stand leg
are secure in the holes (8) on leg bracket.
• Attach other end of the short top leg bracket stamped
D (10) to the front frame assembly using a screw
M6 x12 (3), flat washer 6 (4), spring washer 6 (5) and
hex nut M6 (6).
Make sure that the locking pins on the stand leg are
secure in the holes on leg bracket.
• Attach the other short top leg bracket stamped D (10)
to the front and rear frame assemblies using screws
M6 x12 (3), flat washers 6 (4), spring washers 6 (5)
and hex nuts M6 (6) in exactly the same manner.
(Refer to above steps.)
Make sure that the locking pins on the stand leg are
secure in the holes on leg brackets.
7
3
1 6
4
A
5
8
10
2
9
Fig. 2e
10
4
6
3
5
1
Fig. 2f
5
3
10
4
6
1
2
Fig. 2g
31