Connect To A Dust Collection System; Store The Table Saw Accessories - MasterCraft 055-6755-8 Instruction Manual

46
model no. 055-6755-8 | contact us 1-800-689-9928

CONNECT TO A DUST COLLECTION SYSTEM

(Fig. 26)
The dust extraction port (1) with a 1 7/8" (47 mm)
diameter is located on the rear of the table saw.
This port can be connected directly to a dust collection
system by connecting the pick up end of the dust collection
hose to the dust port.

STORE THE TABLE SAW ACCESSORIES

(Fig. 27)
The table saw has four convenient storage areas (one on
each side and rear of the saw cabinet and right side of
right extension table) specifically designed for the
saw's accessories: push stick (1), rip fence (2), mitre
gauge (3), sub rip fence (4) blade guard (5), anti-kickback
pawls (6), blade wrenches (7). When not in use, turn off
and unplug the saw and store accessories securely.
NOTE:
It is strongly recommended to connect a dust collection system to the dust extraction port.
WARNING!
Table saw must be regularly checked for dust buildup and cleaned frequently;
otherwise, there is a risk of heat buildup and potential fire.
CAUTION!
Care should be taken to position hoses to not interfere with cutting operation.
1
1
Fig. 26
5
1
3
2 4
5
7
6
2
Fig. 27
WARNING!
To reduce the risk of serious personal injury, turn unit off and unplug the tool before making any
adjustments or removing/installing attachments or accessories. An accidental start-up can cause
injury.
WARNING!
Before using the saw, verify the following each and every time:
• ALWAYS wear proper eye, hearing and respiratory equipment.
• Blade is securely tightened.
• Bevel locking lever is locked.
• If ripping, ensure that rip fence locking handle is locked and that the fence is parallel to the
blade.
• If crosscutting, mitre gauge lock knob is securely tightened.
• The blade guard assembly is properly attached and the anti-kickback assembly is functioning.
• Have push sticks available and accessible.
WARNING!
To reduce the risk of serious personal injury, have push stick ready to use before starting cut.
WARNING!
Feed the workpiece into the saw blade only against the direction of rotation. Feeding the workpiece
in the same direction that the saw blade is rotating above the table may result in the workpiece,
and your hand, being pulled into the saw blade.
WARNING!
When the tool is in maintenance or servicing or not in use, ALWAYS turn off saw and unplug the
saw. The saw will automatically shut down when in a power failure, restart the machine by
pressing the green "I" button on the on/off switch.
WARNING!
ALWAYS make sure your workpiece is not in contact with the blade before operating the switch
to start the saw. Blade contact could result in kickback or thrown workpiece.
WARNING!
To reduce the risk of accidental starting, ALWAYS make sure the switch is in the OFF position
before plugging saw into the power source.
WARNING!
DO NOT use blades rated less than the speed of this tool. Failure to heed this warning could result
in serious personal injury.
WARNING!
The operation of any power tool can result in foreign objects being thrown into the eyes, which can
result in severe eye damage. Always wear safety goggles or standard safety glasses with side
shields complying with United States ANSI Z87.1 before commencing power tool operation.
47