MasterCraft 055-6755-8 Instruction Manual page 33

64
model no. 055-6755-8 | contact us 1-800-689-9928
Problem Possible Causes
Material kicked back from • Rip fence out of adjustment.
blade.
• Riving knife not aligned with blade.
• Feeding stock without rip fence.
• Riving knife not in place.
• Dull blade.
• The operator letting go of material
before it is past saw blade.
• Mitre angle lock knob is not tight.
Blade does not raise or tilt Sawdust and dirt in elevation/tilting
freely. mechanisms.
Blade does not come up to • Extension cord too light or too long.
speed or reset trips too • Low house voltage.
easily.
Machine vibrates • The saw is not mounted securely to
excessively. the stand.
• Stand is on uneven floor.
• Damaged saw blade.
Does not make accurate Mitre gauge out of adjustment.
45° and 90° cuts.
Solution
• Align rip fence with mitre gauge
slot.
• Align riving knife with blade.
• Install and use rip fence.
• Install and use riving knife (with
guard).
• Replace blade.
• Push material all the way past saw
blade before releasing work.
• Tighten knob.
Brush or blow out loose dust and dirt.
• Replace with adequate size cord.
• Contact your electric company.
• Tighten all mounting hardware.
• Reposition on flat, level surface.
• Replace blade.
Adjust mitre gauge.
163
164
25
24
31
166
168
169
167
164
31 57 162
168
169
165
166
31 57 162
167 164
65
31 57 162
165
31 57 162
163