Table of Contents
Advertisement
EN
INSTALLATION OF STANDALONE GTB TWINBOX
Remote enable signal
Via a potential-free contact (relay, timer etc) the GTB Twinbox
can be remotely enabled/disabled. The cable is connected to
terminals on CC2, see picture 11 (remote control).
Enable of the GTB Twinbox can be done in two ways:
1. Enable by open circuit (default from factory).
2. Enable by closed circuit.
The setting is done via SW1 DIP4 on CC2, see picture 12
ON = Open circuit enables GTB Twinbox (default)
OFF= Closed circuit enables GTB Twinbox
(bild 11)
10
Hide quick links:
Advertisement
Table of Contents
