Attaching To The Tractor - Landoll 875 Series Operator's Manual

4-3 ATTACHING TO THE TRACTOR

4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Tilloll ring hitch, as
needed, using the swivel jack. Attach the unit
with proper size hitch pin.
4-3.2 Clean all hydraulic couplings and attach
to the tractor. When properly attached, the
hydraulic control lever should cause the
Tilloll to:
a. Lower to the ground when the control arm is
moved forward or downward, and
Figure 4-2 Transport Locks
b. Raise when the control arm is moved back-
4-3.3
4-3.4
ward or upward.
Fully extend the hydraulic gauge wheel
cylinders, and place the cylinder lockouts in
the transport lock position over the cylinder
rods. Secure the lockouts with the lockout
pins (See Figure 4-2).
Always place the swivel jack on the in-
terior mount before setting the machine in
motion.
4-3