3-8 HYDRAULIC FOLD INSTALLATION - ALL FOLD MODELS
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
3-8.1
Install wing fold bracket to wing hinge
using hinge pivot bolt through bracket, wing
hinge, second bracket, and hex lock nut. In-
stall base end of fold cylinders to main frame
cylinder anchor using cylinder pin and hair
pins. Install rod end of fold cylinders to wing
fold brackets inserting hinge pivot bolt
through wing fold bracket, flat washer, yoke,
roller, yoke, flat washer, wing fold bracket,
and hex lock nut. Do not overtighten bolts.
Linkage must be snug, but move freely (See
Figures 3-2 and 3-4).
ITEM
PART NO.
A
1-397-010311102
B
1-397-010311108
C
1-397-010083
D
1-397-010082
E
1-397-0101058
F
3-397-010040
HOSE LENGTH (MODEL USED)
102" (15F)
108" (15F)
28" (15F)
36" (15F)
56" (15F)
21" (15F)
Table 3-3 Hydraulic Fold Hose Installation -
15'F Model
3-8.2
Install short and flat wing supports on
wings using u-bolts and 5/8-11 hex lock nuts.
Refer to Figures 2-1 through 2-7, 3-2, and
3-4 for locations.
o
3-8.3
Install 90
base and rod end of each cylinder.
3-8.4
Install hoses per Figures 3-9 and 3-10
and Tables 3-3 and 3-4.
elbows with restrictors into
3-13