3-15 LUBRICATION
The 875 Series Tilloll must be lubricated before
using it for the first time, and at regular intervals
thereafter. Use a standard multi-purpose grease.
See Section 4-13 to lubricate your 875 Series
Tilloll.
3-16 DECAL PLACEMENT
Decals are extremely important for naming pur-
poses and for alerting others to the presence of
the machine. PLACE ALL DECALS on the Soil
Master II as shown in Figures 3-17 and 3-18.
Center them as nearly as possible between the top
and bottom on the frame bar. Sometimes, shank
spacing may position a tool frame too near the end
of the frame bar to place a reflective tape square
exactly as shown. Then place the square between
the U-bolts on the tool frame as near the proper lo-
cation as possible. A red reflective square is at-
tached to the rear of the left- and right-hand end
tool frames at the factory. If any decals become
unreadable, or are destroyed during use, get re-
placement decals from your Landoll dealer as soon
as possible, and replace them on the machine.
3-28