Hydraulic Fold Installation - All Fold Models - Landoll Wing Tilloll 876 Series Operator's Manual

Hydraulic Fold Installation - All
Fold Models
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Install wing fold bracket to wing hinge using hinge
pivot bolt through bracket, wing hinge, second
bracket, and hex lock nut. Use flat washers as
required outside of fold brackets for spacing. Install
base end of fold cylinders to main frame cylinder
anchor using cylinder pin and hair pins. Install rod
end of fold cylinders to wing fold brackets inserting
hinge pivot bolt through wing fold bracket, flat
washer, yoke, roller, yoke, flat washer, wing fold
bracket, and hex lock nut. Use flat washers as
required outside of fold brackets, center roller, and
cylinder assembly for spacing. Do not overtighten
bolts. Linkage must be snug, but move freely (See
Figures 3-1 through 3-3).
ITEM PART NO.
A 71508992
B 147583
C 153843
D 71508987
E 156945
F 147583
137599
137598
G 116435
153620
H 156963
3/8 X 50 (ALL MODELS)
3/8 X 72 (876-30)
3/8 X 67 (ALL MODELS)
3/8 X 86 (876-30)
3/8 X 100 (876-30)
3/8 X 72 (876-30)
3/8 X 126-1/4 (876-35)
3/8 X 123-1/4 (876-40)
3/8 X 146 (876-35)
3/8 X 140 (876-40)
1/2 X 175 (ALL MODELS)
Table 3-3: Hydraulic Fold Hose Installation
ASSEMBLY INSTRUCTIONS
2. Install short and flat wing supports on wings using
u-bolts and 5/8-11 hex lock nuts. See Figures 2-1
through 2-6, and 3-1 through 3-3 for locations.
o
3. Install 90 elbows with restrictors into base and rod
end of each cylinder.
4. Install hoses (See Figures 3-8 and Table 3-3.)
HOSE LENGTH (MODEL USED)
3-13