Parameter List - Thermo Scientific Lindberg/Blue M Mini-Mite TF55030 Installation And Operating Manual

Mini-mite Tube Furnace
4. To enable the auto-tune, set the A.TUNE parameter to ON by using DOWN
button.
5. Press the PAGE
TUNE to indicate that tuning is in progress.
The auto tune is completed when the regular display of the measured temperature is
shown and the process is allowed to control at the target set point using the new control
terms.
NOTE
If the process temperature or load changes significantly another auto tune

session may be necessary to optimize the chamber performance.
If the controller is auto tuning and sensor break occurs, the auto tune will abort.

Auto tune must be re-started when the sensor break condition is no longer
present.
If an Auto tune cannot be performed an error message, Etun will be flashed in the

display.
Auto tune will not work when controller is running program or Timer.


Parameter List

Parameters are available under different levels of security and are defined as Operator
Level 1 (LEv1) & Operator Level 2 (LEv2). This section describes various parameters used
in each operator levels.
Operator Level 1
Operator level 1 is designed for day to day operation of the controller and parameters are
not protected by a security code. From HOME display, press SCROLL
through the list of parameters in Level 1.
The parameter mnemonic and its scrolling description are shown in the lower display. The
value of the parameter is shown in the upper display. After 5 seconds, a description of the
parameter will scroll once along the display and then revert back to the mnemonic. The
scrolling text can be interrupted at any time by a single press of any of the buttons, but
will not scroll again until the parameter is returned to.
Main Controller: 1x8 & 5x16 Segment Programmable |
button to return to the HOME display. The display will flash
Chapter 6
or UP
button to scroll
304243H02 | 6-26