Operator Buttons; Single Set Point Operation - Thermo Scientific Lindberg/Blue M Mini-Mite TF55030 Installation And Operating Manual

Mini-mite Tube Furnace

Operator Buttons

+

Single Set Point Operation

3216 controller has capability to select set point-1 and set point-2. User can setup two
different set points to select the desired set point, SP.SEL function can be used.
To set the desired temperature set point, complete the following steps:
1. Press the SCROLL
2. Press UP or DOWN
release the button. A few seconds after the button is released, the controller will
accept the new value and is indicated by a brief flash of the display.
3. Press PAGE button to return to the HOME display.
Main Controller: 1x8 & 5x16 Segment Programmable |
Press to select a new list of parameters and from any
display - press PAGE to return to the HOME Page
Press to select new parameter from the page header. If held
down it will continuously scroll through parameters.
Hold down SCROLL and press UP ARROW to scroll back
parameters.
Press to decrease or change the state of a value.
Press to increase or change the state of a value.
button until SP1 or SP2 is displayed.
button until the desired setpoint is displayed and then
Chapter 6
304243H02 | 6-22