Thermo Scientific Lindberg/Blue M Mini-Mite TF55030 Installation And Operating Manual page 46

Mini-mite Tube Furnace
To Configure the Programmer
1. Enter level 2: refer to section "To Enter Level 2" for steps to enter Level 2.
2. To select the Programmer, press
'PROG'.
3. To configure the first Program, press DOWN
number '1'.
Similarly you can configure program (1, 2, 3, 4 or 5) for configuration.
4. To set the ramp unit, press SCROLL
press DOWN or UP
the ramp unit is set in min).
5. To set the Dwell unit, press SCROLL
Press or to select hour or min (In this example the dwell unit is set in
min).
6. To set the first Target Set point, press SCROLL
Press DOWN or UP
7. To set the first Ramp rate, press SCROLL
DOWN or UP
Main Controller: 1x8 & 5x16 Segment Programmable |
as many times as necessary to view
or UP
button to select 'RAMP.U' and then
button to select hour, min or sec (In this example
button to select 'DWEL.U' and then
button to set the value.
button to select 'RMP.1'. Press
button to set the value.
Chapter 6
to select program
button to select 'TSP.1'. Then
304243H02 | 6-44