Table of Contents
Advertisement
| Main Controller: 1x8 & 5x16 Segment Programmable
Chapter 6
|
6-21
304243H02
Operator Interface & HOME Display
When the controller is turned ON, it will perform a brief self-test and then display the
HOME Display page. The measured value (process value) is found in the upper display
and the set point is found in the lower display.
The description of interface beacons and buttons are shown in "Beacon Display and
Description" & "Operator Buttons" respectively.
Output status Beacon
Alarm Beacon
Page Button
Scroll Button
Beacon Display and Description
OP1 (Output 1)
Illuminates when the output to heater
OP4 (Output 4)
Illuminates when the output is ON (Over-temperature alarm).
SPX
Alternative set point in use (SP2)
ALM
Alarm active (Red)
REM
Remote set point or communication active
RUN
Timer running for 3216c or Program running for 3216p
RUN (flashing)
Timer hold for 3216c or Program hold for 3216p
Up Arrow Button
Down Arrow Button
Units of Measure
Measured Temperature
(or process value 'PV')
Required Temperature
(or Set Point 'SP')
Setpoints (SP) Display and
Scrolling Text Messages
Mini-mite Tube Furnace
Hide quick links:
Advertisement
Table of Contents
