Changing The Wristband - Withings ScanWatch Series Installation And Operating Instructions Manual

Note:
• ScanWatch charger is the same for the 38mm and 42mm models.
• The Steel HR charger cannot be used for ScanWatch.
• Charging time is about 3 hours.

Changing the wristband

You can easily change the wristband of your ScanWatch thanks to the quick
release spring bars with which it is attached. The 38-mm model requires
wristbands that are 18-mm wide, while the 42-mm model requires wristbands
that are 20-mm wide.
Notes:
The 38-mm model fits wrists from 146 mm (5.7") up to 211 mm (8.3").
•
• The 42-mm model fits wrists from 163 mm (6.4") up to 239 mm (9.4").
To change the wristband, perform the following steps:
1. Turn your ScanWatch over.
2. Locate the knob of each spring bar.
3. Pull the knob of the first spring bar to the left side and remove the wristband.
4. Insert one side of the spring bar of the new wristband.
ScanWatch
v1.0 | August, 2020
EN - 88