Withings ScanWatch Series Installation And Operating Instructions Manual page 85

2. Go to the Settings of your mobile device, select Bluetooth and locate
ScanWatch XX in the list of devices. Select the small icon to the right and
select the option to Forget the device.
3. Press and hold the button on the side of the watch for 5 seconds. Depending
on how your watch was configured, ECG, SpO2, or Workout mode will start
after pressing the button for about one second, but continue pressing until a
menu appears on the watch's display.
4. When on this menu, press the watch button until the screen shows Factory
Reset.
5. While the watch shows Factory Reset, press and hold the watch button for
one second and you will see Reset in 5 clicks.
6. Press the button 5 times and the watch will be reset to factory settings. While
this occurs, the word Reset will appear on the watch's display.
7. The watch will now restart and show Hello! on its display. Please note that
if the watch does not show Hello!, this means that the factory reset was not
successful and so it must be performed again.
8. You can now reconfigure the watch. Refer to
page 8 if you want to install your ScanWatch, again.
ScanWatch
v1.0 | August, 2020
"Setting up my watch" on
EN - 85