Using Hex Dump Mode; Initializing The Ethernet Card - Epson Stylus Color 850Ne Specifications

Epson stylus color 850ne: specifications
Hide thumbs Also See for Stylus Color 850Ne:
Table of Contents

Advertisement

4. Hold down the
oad/eject button and press the
E
l
button. Hold down the buttons until the
starts to flash, then release them.
The printer prints on the first and last lines of one sheet of
paper, then prints a nozzle check pattern (shown on
page 12) and samples of fonts and colors.
5. To end the test, turn off the printer. Then reconnect the
network cable and turn on your printer and computer.

Using Hex Dump Mode

You can use the printer's hex dump mode to identify problems
if you know how to interpret hex code. Follow these steps:
1. Make sure the printer is turned off and has paper loaded
in it.
2. Open the cover.
load/eject button and the
3. Hold down the
E
cleaning button and press the
prints Hex Dump Mode at the top of a page and then
stops.
4. Print one or more pages from an application as usual. The
printer prints the exact code it receives in hexadecimal
format.
5. Turn off the printer to exit hex dump mode.
Printing an Ethernet Card Status
Sheet
You can print a status sheet to see information about your
Ethernet card including the serial number, MAC address, and
network information. You need the status sheet information
to configure your card. Follow these steps:
1. Make sure the printer is turned on and has paper in the
feeder.
status sheet button
2. Press the status sheet button and hold it for about three
seconds to print out the status sheet.
power
P
power light
P
color
X
power button. The printer
P
Reading the Ethernet Card Status
Lights
The status lights on the Ethernet card plate provide you with
the basic printer and network status.
red status
light
green status
light
The red and green status lights indicate the following:
Red
Green
Blink together
Off
Flashes slowly
Off
Flashes rapidly
Off
On
On
Off

Initializing the Ethernet Card

You only need to initialize the card under the following
conditions:
The first time you connect the printer to a network
If there is an error communicating with the Ethernet card
When you reinstall the card in a different printer
Follow these steps to initialize the Ethernet card:
1. Turn off the printer.
It will take several seconds for the Ethernet card to power
down. Wait until the status lights on the card go out before
continuing to step 2.
2. Turn on the printer while pressing and holding down the
status sheet button for about five seconds.
When the red and green status lights start to flash
simultaneously, stop pressing the status sheet button.
Initialization is complete when the status lights stop
flashing.
3. After initialization is complete, press the status sheet button
and hold it for about three seconds to print a status sheet. If
the card initialized, the IP address reads 11.22.33.44.
Note:
You can also initialize the Ethernet card using its internal home page.
See your Administrator's Guide for more information.
10/98
EPSON Stylus COLOR 850Ne
Status
Printer and Ethernet card are initializing
Printing data or the status sheet
Sending and receiving packets
Normal ready status
Error status
EPSON Stylus COLOR 850Ne
- 7

Advertisement

Table of Contents
loading

Table of Contents