Inverter Factory Setting - Siemens SINAMICS G120 CU230P-2 HVAC Operating Instructions Manual

Commissioning
4.2 Preparing for commissioning
4.2.1

Inverter factory setting

Factory settings of additional important parameters
Parameter Factory setting
p0010 0
p0100 0
p0300 1
p0304 400
p0305 depends on the
Power Module
p0307 depends on the
Power Module
p0308 0
p0310 50
p0311 1395
p0335 0
p0625 20
p0640 200
p0970 0
P1080 0
P1082 1500
P1120 10
P1121 10
P1300 0
58
Meaning of the factory
setting
Ready to be entered
Europe [50 Hz]
Induction motor
[V]
[A]
[kW/hp]
[cos phi]
[Hz]
[rpm]
Non-ventilated: Shaft-
mounted fan in the motor
[°C]
[A]
Locked
[rpm]
[rpm]
[s]
[s]
V/f control with linear
characteristic
Frequency inverters with Control Units CU230P-2 HVAC, CU230P-2 DP, CU230P-2 CAN
Name of the parameter and comments
Drive, commissioning parameter filter
IEC/NEMA motor standard
IEC, Europe
•
NEMA, North America
•
Note: This parameter cannot cannot be changed in FW4.3.
Motor type selection (induction motors / synchronous motor)
Rated motor voltage (in accordance with the rating plate in V)
Rated motor current (in accordance with the rating plate in A)
Rated motor power (in accordance with the rating plate in
kW/hp)
Rated motor power factor (in accordance with the rating plate in
cos 'phi'). If p0100 = 1, 2, then p0308 has no significance.
Rated motor frequency (in accordance with the rating plate in
Hz)
Rated motor speed (in accordance with the rating plate in rpm)
Motor cooling type (specify the motor cooling system)
Motor ambient temperature
Current limit (of the motor)
Reset drive parameters (restore to the factory settings)
Minimum speed
Maximum speed
Ramp-function generator, ramp-up time
Ramp-function generator, ramp-down time
Open-loop/closed-loop control operating mode
Operating Instructions, 01/2011, FW 4.4, A5E02430659B AD