Siemens SINAMICS G120 CU230P-2 HVAC Operating Instructions Manual page 97

Defining the analog output function
You define the analog output function by interconnecting parameter p0771 with a connector
output of your choice. Parameter p0771 is assigned to the particular analog input via its
index, e.g. parameter p0771[0] is assigned to analog output 0.
Table 5- 9
CO
r0021
r0024
r0025
A complete list of the connector outputs is provided in the List Manual.
Table 5- 10
|i|
For more information, see the parameter list and the function block diagrams 9572 ff of the
List Manual.
Advanced settings
You can manipulate the signal that you output via an analog output, as follows:
● Absolute-value generation of the signal (p0775)
● Signal inversion (p0782)
Additional information is provided in the parameter list of the List Manual.
Frequency inverters with Control Units CU230P-2 HVAC, CU230P-2 DP, CU230P-2 CAN
Operating Instructions, 01/2011, FW 4.4, A5E02430659B AD
Connector outputs (CO) of the inverter (selection)
Significance
Actual frequency
Output actual frequency
Output actual frequency
Example:
p0771
r0027 27
CO
r0026
r0027
Output the inverter output current via analog output 0.
Adapting the terminal strip
5.5 Analog outputs
Significance
Actual DC link voltage
Output current
95