Brother PRCF5 User Manual page 6

■ Adjusting the cap frame driver
1 L-shaped bracket
2 Ring
Memo
● If the same machine is being used, the
adjustment to the cap frame driver is only
required the first time that the machine is
used.
1 Turn on the machine, using its main power
switch. After the carriage moves to its initial
position, turn off the machine.
Note
● Be sure to adjust the cap frame driver with
the carriage at its initial position.
2 Using the Allen screwdriver (medium),
loosen the two hexagonal screws one turn in
the direction of the arrow.
1 Hexagonal screws
2 Allen screwdriver (medium)
Note
● Do not loosen the screws too much.
3 Lower the L-shaped bracket so that it
touches the machine bed, and then use the
Allen screwdriver (medium) to firmly tighten
the two hexagonal screws.
1 L-shaped bracket
4 Using the Allen screwdriver (large), loosen
the four hexagonal screws on the inside of
the ring one turn in the direction of the
arrow.
1 Hexagonal screws
2 Allen screwdriver (large)
When the screws are loosened, the ring
can be lowered.
Note
● Do not loosen the screws too much.
5 Insert the pad between the machine bed and
the ring of the cap frame driver.
1 Pad
2 Machine bed
3 Ring of the cap frame driver
5/15