Ribbon Sensor - Xerox QLS-8100XE Operation & Setup Manual

Ribbon Sensor

This function is for use by QuickLabel Systems' technicians when
performing diagnostics at the factory. In general use, the TTR Sensor should
always be enabled.
To adjust the ribbon sensor:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Ribbon menu is displayed.
Then press the SELECT key.
Pause: Ribbon
3 Press the NEXT or PREVIOUS key until the Ribbon Sensor menu is
displayed.
4 Press the + or – key until the desired sensor setting is displayed.
Available options are Enabled or Disabled. Under normal operating
conditions, the sensor should be enabled.
5 Press the SELECT key to confirm your choice.
Caution: This capability is intended for factory diagnostics only. Do not
disable the sensor. Use of the printer with the ribbon sensor disabled could
result in damage to the printhead (due to overheating) and/or poor print
quality.
QLS-8100 Xe
Press SELECT
Ribbon Sensor
Enabled
4-35