Power Connection - Xerox QLS-8100XE Operation & Setup Manual

Power Connection

1 Locate the AC Power Input at the bottom of the rear panel.
2 Plug the power cord into the printer. Be sure to use only the AC Power
Cord supplied with the printer. Ensure that the power switch is in the
OFF position before proceeding to the next step.
3 Connect the opposite end of the AC Power Cord into an earth grounded
AC receptacle. Do not power the printer on until you have finished
making the remaining connections described in this chapter.
Warning: Do not use any type of receptacle adapter or AC Power Cord that
has not been supplied with the unit. Doing so can result in damage to the
printer.
Note: The printer has been set at the factory for the correct line voltage for
your country. The voltage setting can be viewed in a window at the top of
the AC Power Input. If this setting needs to be changed, refer to the
procedure in Chapter 7 of this manual.
Note: It is recommended that an AC line conditioner / surge suppressor is
used. Select a unit that is capable of handling the power requirements of the
printer and protecting from surges and spikes. A VA rating of at least 350
VA is required.
QLS-8100 Xe 2-11