Pull Back - Enable/Disable - Xerox QLS-8100XE Operation & Setup Manual

Pull Back - Enable/Disable

You can enable/disable the pull back function using the Pull Back option
under the Options menu. This option requires a compressed air connection
and special hardware.
Contact QuickLabel Systems for more information about the pull back
function.
Note: The printer must be equipped with the media Pull Back option.
Otherwise, the printer will return an error message if Pull Back is activated
but the option is not present.
To enable media pull back:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Options menu is displayed.
Then press the SELECT key.
Pause: Options
3 Press the NEXT or PREVIOUS key until the Pull Back menu is displayed.
4 Press the + or – key to choose Enable. Available options are Enabled or
Disabled.
5 Press the SELECT key to confirm your choice.
Note: Media rewind can also be activated via host command. Consult the
QuickLabel Systems Host Protocol documentation for details on this
command.
QLS-8100 Xe
Press SELECT
Pull Back
Enabled
4-57