Xerox QLS-8100XE Operation & Setup Manual page 52

Ribbon Menu
Ribbon Type
Drop/Lift Adjust
Ribbon Sensor
Communications
Menu
Data Port
Parallel Mode
RS232 Baud Rate
RS232 Handshaking
TCP/IP Address
TCP/IP Subnet Mask
TCP/IP Gateway
4-6
Options are available in a Pause state only.
Selects printhead intensity tailored to a specific
media type. Possible values are Standard and
Resin/Synthetic.
Adjust the drop and lift point for printheads 1 – 4.
Possible values are 0 to +40 mm.
Used by QuickLabel Systems' technicians when
performing factory diagnostics. Possible values are
Enabled and Disabled, but in general use, the
sensor should always be enabled.
Options are available in a Pause state only.
Selects the data input interface used by the printer.
Possible values are Parallel, Serial, or Ethernet.
Specifies the mode of connection for the parallel
port. Possible values are Auto or Standard.
Specifies a baud rate for the RS232 serial port.
Possible values are 4800, 9600, 19200, or 38400.
Specifies a handshaking method for the RS 232
serial port. Possible values are Hardware or
XON/XOFF.
Specifies the IP address of the printer for ethernet
purposes.
Specifies the subnet mask.
Specifies the default gateway.
Keypad controls and menus