Utility Port Connection - Xerox QLS-8100XE Operation & Setup Manual

Utility Port Connection

On the rear panel of the printer, the Utility Port permits connection to
external devices such as the optional QuickLabel Systems Cutter and
Cutter/Stacker or a label applicator system. The assignment of pin functions
on the utility port depends on the mode of operation. For additional
information regarding applicator mode operation, please contact QuickLabel
Systems.
Standard Mode
Pin Signal
1 N/C
2 Ground
3 Cutter On/Off Output (1=on 0=off)
4 5 VDC
5 Cutter
6 Cutter Pulse
7 N/C
8 Pause
9 Error
Applicator Mode
Pin Signal
1 N/C
2 Ground
3 Printing
4 N/C
5 N/C
6 N/C
7 N/C
8 Go
9 Skip/Apply
Note: If you are using a cutter or cutter/stacker, refer to the unit's setup and
operation manual for information on setting up the unit with your printer.
Warning: Exceeding the limits of the utility port signals can result in damage
to the printer.
2-16
Notes
1A max
Error Input (1=error 0=no error)
~ 250 nsec pulse output
Input
(1=print 0=pause)
Notes
Output (1=printing)
Input (1=initiate print)
Output (1=apply 0=skip)
5
9
6
1
Physical setup