Xerox QLS-8100XE Operation & Setup Manual page 63

3 Press the + or – key until the desired horizontal offset setting is
displayed.
Offset settings range from <– 600 to -> 600 pixels (or dots). On the
QLS-8100 Xe, there are 12 pixels per millimeter. The final image position
will be constrained by the label width.
4 Press the SELECT key to confirm your choice.
Partially printed labels under the printheads will finish printing using
the previous offset to ensure color alignment. During this time, you
cannot adjust the cross web or horizontal offset values. The new
horizontal adjustment will affect subsequent labels.
Note: Setting the offset via software will always override this setting. You
can set the offset via Color QuickLabel 99.
QLS-8100 Xe 4-17