Network Scan Procedure - Xerox WORKCENTRE 4150 User Manual

5 Network Scan

Network Scan Procedure

1 Load the Documents
56
This section describes the basic procedure for network scanning. Follow the
steps below.
Load the Documents – page 56
Select Network Scanning – page 57
Select Network Scanning Template – page 58
Change Feature Settings – page 58
Start the Network Scanning Job – page 59
Job Status Screen – page 59
Stop the Network Scanning Job – page 60
NOTE:
If the Authentication feature is enabled, you may need an account
number before using the machine. To get an account number, or for more
information, contact the Key Operator or the System Administrator.
You can load the documents to be scanned either on the Document Glass or
through the Document Feeder.
Document Feeder:
The following steps explain how to load documents using the document
feeder:
1.
Before loading the documents into the document feeder, ensure they are
in good condition and remove all staples and paper clips.
2.
Insert the documents neatly into
the document feeder, face up. The
first page should be on top with
the headings towards the left of
the machine.
3.
Place the stack in the middle of
the guides aligning the left edge
with the document feeder tray, and
position the guides to just touch
the edge of the documents.
Xerox WorkCentre 4150 User Guide