Gastroback ADVANCED PRO S Operating Instructions Manual page 58

Problem
The juice splashes.
Liquid (juice) accumulates
under the appliance AND/
OR liquid runs out from
under the juice spout.
Immediately unplug the
appliance!
You find it difficulty to
take out the juice collector
AND/OR the juicing cone
cannot be removed.
EN
58
Possible Reasons
The juice spout is folded
up to the closed position.
The juice outlet of the jui-
ce collector is clogged.
The juice collector is over-
filled.
The juice collector is over-
filled.
The juice collector is lea-
king.
The juicing cone sticks to
the drive shaft.
The Easy Solution
Place a sufficiently large juice vessel under the juice spout (at
least 1/2 litres) and push down the juice spout for opening the
juice outlet of the juice collector. Leave the juices flow out.
Remove any obstacles clogging the juice outlet, before the
juice reaches the rim of the filter basket (see: 'Operation /
Emptying the Filter Basket and Removing Obstacles').
During operation, always ensure that a suitable juice ves-
sel is placed under the juice spout and the juice spout is
in the lower open position. Ensure that the juice flows
freely out of the juice outlet of the juice collector. Remo-
ve blockages in time (see: 'Operation / Emptying the
Filter Basket and Removing Obstacles').
Check the following items (see: 'Operation / Emptying
the Filter Basket and Removing Obstacles'):
- Is the juice spout closed? Place a sufficiently large juice
vessel under the juice spout (at least 1/2 litres) and
push down the juice spout for opening the juice outlet
of the juice collector.
- Is the filter basket clogged or overfilled with pulp? Emp-
ty the pulp. If required, rinse the filter basket.
- Is the juice outlet of the juice collector clogged? Remo-
ve the obstacle.
Replace the juice collector. Get in contact with your ven-
dor. Do not use the appliance, when any part of it is
damaged or leaking.
At the back (side of the press arm) lift the juice collector
upwards a little. Then, if required, turn the juice collector
a little to and fro, until it comes out of the top plate of
the motor base easily.
When residues of food get on the drive shaft or the interior of
the juicing cone, the juicing cone may stick to the drive shaft.
In this case, carefully pull the juicing cone straight upwards for
removing the juicing cone first. Thereafter, you can take out
the juice collector with the filter basket. Clean the drive shaft
and the interior of the juicing cone thoroughly, removing any
residues of food (see: 'Care and Cleaning'). Ensure that the
drive shaft and interior of the juicing cone are clean, when
placing the juicing cone onto the drive shaft.