Using An Automatic Dish-Washer; Cleaning The Motor Base And Power Cord - Gastroback ADVANCED PRO S Operating Instructions Manual

NOTE
Before cleaning, soak dried-on residues of food sticking to the removable parts for
approx. 10 minutes in lukewarm dishwater. You may clean the removable parts
(fruit come, juicing cone, filter basket, juice collector) in an automatic dishwasher
(see: 'Using an Automatic Dish-Washer').
4. Clean fruit dome, juicing cone, filter basket, and juice collector with a soft nylon
brush and warm dishwater.
5. Ensure that there are no residues of juice or pulp left in the interior of the
juicing cone. If required, use a little bottle brush for cleaning the interior of the
juicing cone. Otherwise the juicing cone could stick stubbornly at the drive shaft.
6. Ensure to clean the juice outlet and juice spout of the juice collector thoroughly.
This may avoid clogging on later use. However, do not poke in the juice outlet
or juice spout, but rinse these parts via a jet of tap water.
7. After cleaning, rinse with clear tap water and wipe dry with a soft cloth. Leave
the parts dry naturally for approx. 1/2 hour, where they are out of reach of
children younger than 8 years.

USING AN AUTOMATIC DISH-WASHER

Juicing cone, filter basket, juice collector, and fruit dome may be cleaned in an
automatic dish-washer. However, do not place the motor base in the dish-washer!
Even when cleaning the removable parts in an automatic dish-washer, always rinse
the parts of the juicing system under running tap water immediately after use. Doing
so, especially ensure to purge all residues of pulp out of the juice outlet and juice
spout of the juice collector. Dried-on residues of fibres could adhere stubbornly to the
surfaces, making it extremely difficult to get these parts really clean.
For cleaning, place all parts in the upper rack and select a low temperature.

CLEANING THE MOTOR BASE AND POWER CORD

WARNING
arm. Remove any residues with a damp, not dripping cloth. Do not use any hard
objects for scraping off residues of food. Do not pour any liquids into the top plate
of the motor base.
EN
60
– Do not poke under the drive shaft or in the joint of the press