Snmp Configuration (Connectivity > Protocol) - Xerox WorkCentre 5019 Network Addendum

IPv6
– Enable Manual Address:
You can check this checkbox to enter the IP address and gateway address directly. (Default:
Off)
• IP Address:
You can enter the IP address when the Enable Manual Address checkbox is selected.
• Automatically Configured Address 1:
The IPv6 address set automatically is displayed.
• Link-Local Address:
The link-local address set automatically is displayed.
• Gateway Address:
You can enter the gateway address when the Enable Manual Address checkbox is
selected.
• Automatically Configured Gateway Address:
The gateway address set automatically is displayed.
SNMP configuration (connectivity > protocol)
You can set the SNMP protocol.
General
• SNMP Port Status
You can check Enabled to use SNMP. (Default: On)
• Edit SNMP v1/v2c Properties button
You can make advanced SNMP v1/v2c settings by pressing this button.
– Community Name (Read Only):
You can enter the community name to acquire (up to 32 ASCII code characters). (Default:
blank (public))
– Community Name (Read/Write):
You can enter the community name to acquire/write (up to 32 ASCII code characters).
(Default: blank (private))
– Trap Community Name:
You can enter the community name for trap notification (up to 32 ASCII code characters).
(Default: blank (SNMP_trap))
– System Administrator's Login ID:
You can enter information related to the person in charge of maintenance of the machine (up
to 127 ASCII code characters)(Default: blank).
Authentication failure generic traps
You can check Enabled to send an authentication failure trap notification when an access attempt was
made with an invalid community name not registered in the machine. (Default: On)
20 ® ®
Xerox WorkCentre 5019/5021
Network Addendum