Common Specifications For All Models - Xantrex XTR6-110, XTR8-100, XTR12-70, XTR20-42, XTR33-25, XTR40-21, XTR60-14, XTR80-10.5, XTR100-8.5, XTR150-5.6, XTR300-2.8, XTR600-1.4 Operating Manual

Table C-3 Remote Operation
Programming Mode
Output Voltage and Current Monitor
On/Off Control
AUX On/Off Control
Power Supply Status Signal
Interlock Enable/Disable

Common Specifications for All Models

Output Performance Specifications
Temperature Coefficient
Drift (8 hours)
Hold-up Time
1
Transient Response Time
Meter Accuracy
Isolation
AC Input to Output
AC Input to Chassis
Output to Chassis
1.Time for the output voltage to recover within 0.5% at its rated output for a load change 10–90% of rated output current. Output set point
10–100%.
APG
0–100%, 2~ up to 10 V, programmable
100 PPM/° C from rated output voltage, after a 30-minute warm-up
0.05% of rated output (over an 8 hour interval with constant line, load and temperature, after a 30-minute warm-up)
Typical 20 ms at any rated input line.
Less than 1 ms for 6 V to 60 V models. Less than 2 ms for 80 V to 600 V models
0.5% ± 1 count
1350 Vac
1350 Vac
500 Vac
ISOL
TTL level
TTL level or dry contact
TTL high: OK
TTL low: fail
Dry contact. Open/Short: On or Off,
programmable
Digital