Xantrex XTR6-110, XTR8-100, XTR12-70, XTR20-42, XTR33-25, XTR40-21, XTR60-14, XTR80-10.5, XTR100-8.5, XTR150-5.6, XTR300-2.8, XTR600-1.4 Operating Manual page 181

4. From the Hyper Terminal (or any other terminal program) select the
5. Navigate to and select the text file that was previously stored. Click
6. Execute the program recording stop command:
7. Execute the readback command to verify the entire program was
8. Set the data rate back to the original speed.
9. Close the connection to the HyperTerminal program and configure
Running an Auto Sequence Program:
Once an auto sequence program has been stored, there are a few
commands that can be used to run the program. Once a program begins
running, it will continue running until completion and then repeat the
number of times specified by the repeat command. The default at power
on is to have repeat set to 1.
Commands:
*TRG
[:]INITiate[<channel>][:IMMediate]
[:]PROGram[<channel>]:STATe {?|RUN|STOP|PAUSe}
Where:
RUN causes the program to begin execution.
STOP causes the program to stop execution
PAUSe causes the program to stop executing at the current command. If a
subsequent run is sent, the program will resume executing with the next
command in the program.
For Example:
975-0200-01-01
Transfer>Send Text File...
the Open button.
:PROG:STOP
transferred correctly:
PROG:READ?
the connection data rate to be the original speed.
:PROG:STAR
*IDN?
*IDN?
:PROG:STOP
Locking and Unlocking the Front Panel
5
5-59