2.10
c
(
)
onnection of exPansion moDules
for biPhase or triPhase confiGuration
CARRY OUT THE FOLLOWING STEPS:
a. Remove the master module side cover by undoing the fastening screws
b Connect the flat cables supplied with the expansions to CPU card by inserting them into the appropriate connectors.
c. Fix the side cover of the master with the specific screws
d� Remove the front cover of the expansion modules undoing the fastening screw of the cover and correctly install the master
module and the expansion module to the panel as described at paragraph 2.4.
e� Fasten the screw to secure the product in position.
f� Connect the two flat cables from the CPU card by inserting them into the correct connector of expansion.
g� The cables flat already are inserted in the indicated connector of the expansion
h� Do not pull the flat cable to avoid to damage it.
i� Place the flat cable into the product and close the front cover of expansions.
j� Check the front covers are properly closed with the screws.
Figure 7
12
80993B_MHW_GFW-Xtra_06-2018_ENG