Chapter 3 Installation and Configuration
The S5U13L02P00C100 Evaluation Board incorporates a DIP switch, jumpers, and 0 ohm resistors which allow it
to be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13L02 has 2 configuration inputs (CNF[2:1]). A DIP switch (SW1) is used to configure CNF[2:1] as
described below.
S5U13L02P00C100
SW1-[2:1] Config
CNF[2:1] Config
SW1-[2]
SW1-[1]
= Required settings when using S5U13U00P00C100 USB Adapter board
The following figure shows the location of DIP switch SW1 on the S5U13L02P00C100 Evaluation Board.
S5U13L02P00C100 Evaluation Board User Manual (Rev. 1.0) EPSON
Table 3-1: Configuration DIP Switch Settings
S1D13L02
CNF2
Big Endian
CNF1
Indirect 68
Figure 3-1: Configuration DIP Switch (SW1) Location
Power-On/Reset State
1 (ON)
Little Endian
Indirect 80
Chapter 3 Installation and Configuration
0 (OFF)
7