Clocks; Reset - Epson S5U13L02P00C100 User Manual

Note
H4 connector is not mounted. There is allocated space for the connector.

4.2 Clocks

The clock for the S1D13L02 LCD controlleris provided by a 4MHz oscillator.
Note
The on-board 4MHz oscillator is not specified to work below a 3.0V supply voltage.

4.3 Reset

The S1D13L02 LCD controlleron the S5U13L02P00C100 Evaluation Board can be reset using a push-button switch
(SW2), or via an active low reset signal from the host development platform (pin 33 on the H1 connector).
Note
H1 connector is not mounted. There is allocated space for the connector.
S5U13L02P00C100 Evaluation Board User Manual (Rev. 1.0) EPSON
Figure 4-1: Reset Switch (SW2)
Chapter 4 Technical Description
13