Adjustments - The Handy THS80 Instruction Manual

ADJUSTMENTS

STEP 6
When you have finished all the above steps, if the hole at the bottom of hopper cannot be closed
and opened completely by using the handle you may need to the follow these additional steps.

Release the two bolts M5x10 on clamp as shown.

Push the handle to the top position, use your hand to adjust the adjustable plate so as to make
sure the hole at the bottom of the hopper can be closed completely.

Push the handle to the lowest position, use your hand to adjust the adjustable plate so as to
make sure the hole at the bottom of the hopper can be opened completely.

Tighten the bolts and nuts on clamp.
To operate this spreader, push the handle to the lowest position (downwards). You may move the
position of the Wing nut on the Gauge & Lever to adjust the space on the hole between the
hopper and the adjustable plate as per your need when spreading.