Adjustments - The Handy THSSALT Instruction Manual

STEP 3 – Connecting Linkage
•
Push the flow control handle to the "30" position. Insert the A end of the connecting rod (#34)
through the Ø8 flat washer (#12) and into the hole on the gauge level plate (#46). Secure with a
M8 lock nut (#11).
•
Insert the B end of the connecting rod (#34) through the Ø8 flat washer (#12) and into the hole
on the fixed plate (#13). Secure with M8 lock nut (#11).
•
Push the control handle to the "0" position. The hole in the bottom of the spreader should be
completely closed.

ADJUSTMENTS

STEP 4
When you have finished all the above steps, if the hole at the bottom of hopper cannot be closed
and opened completely by using the handle you may need to the follow these additional steps.
•
If the flow control handle position and the hole in the bottom of the hopper does match exactly,
loosen the two bottom M6 lock nuts (#9) and move the gauge level plate until the handle
position and the hole in the bottom of the hopper match.
•
Re-tighten the two M6 lock nuts (#9).
To operate this spreader, push the handle to the lowest position (downwards). You may move the
position of the Wing nut on the Gauge & Lever to adjust the space on the hole between the
hopper and the adjustable plate as per your need when spreading.
A
B