Rigol DS1000Z-E Series User Manual page 136

RIGOL
BY: the Y value at cursor B. Y value takes the channel GND of CH1 as reference.

Its unit is the same as that of the current signal source.
BX-AX: the horizontal difference between cursors A and B.

BY-AY: the vertical difference between cursors A and B.

|dX|: when the horizontal unit is set to "s", |dX| represents the time difference

between cursor A and cursor B; when the horizontal unit is set to "Hz", |dX|
represents the frequency difference between cursor A and cursor B.
1/|dX|: the frequency difference between cursor A and cursor B.

If needed, please refer to the following steps to modify the parameters of manual
cursor measurement.
1. Select Cursor Type
Press Select to select "


2. Select Measurement Source
Press Source to select the waveform of the analog channels (CH1 and CH2),
math operation results (MATH) waveform for measurement.
Note:
3. Adjust Cursor Position



Note:
cursor.
4. Select X (Y) Axis Unit
Press Units to set the horizontal unit and vertical unit of the cursor
measurement.
Press Hori.Unit to select "s", "Hz", "Degree" or "Percent".


6-36
Find Quality Products Online at:
" or "
: the X cursors are a pair of vertical solid (cursor A)/dotted (cursor B)
lines and are usually used to measure time parameters.
: the Y cursors are a pair of horizontal solid (cursor A)/dotted
(cursor B) lines and are usually used to measure voltage parameters.
Only channel currently enabled can be selected.
Adjust cursorA: press CursorA and use
cursorA. The measurement result will change accordingly during the
adjustment and the adjustable range is limited within the screen.
Adjust cursorB: press CursorB and use
cursorB. The measurement result will change accordingly during the
adjustment and the adjustable range is limited within the screen.
Adjust cursorA and cursorB at the same time: press CursorAB and use
to adjust the positions of cursorA and cursorB at the same time. The
measurement result will change accordingly during the adjustment and the
adjustable range is limited within the screen.
You can also press down
s: when this unit is selected, in the measurement results, AX, BX and BX-AX
are in "s" and 1/|dX| is in "Hz".
Hz: when this unit is selected, in the measurement results, AX, BX and |dX|
GlobalTestSupply
www.
Chapter 6 MATH and Measurement
".
to adjust the position of
to adjust the position of
knob continuously to switch the current
DS1000Z-E User Guide
.com
sales@GlobalTestSupply.com