Rigol DS1000Z-E Series User Manual page 99

RIGOL
― After selecting this condition, you can press Mode to set the CS mode to
Timeout: the clock (SCL) signal need to maintain a certain idle time before the

oscilloscope searches for a trigger. The oscilloscope will trigger on when the data
(SDA) satisfying the trigger conditions is found. After selecting this condition,
you can press Timeout to set the minimum idle time and the range is from 100
ns to 1 s.
Clock Edge:
Press ClockEdge to select the desired clock edge.


Trigger Mode:
Press Sweep to open the trigger mode list and select auto, normal or single. For the
details, please refer to "Trigger Mode". The corresponding status light of the
current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameter (noise rejection) under this trigger type.
Trigger Level:
When SCL is an analog channel, press SCL and use TRIGGER
the trigger level of the SCL channel. When SDA is an analog channel, press SDA and
use TRIGGER
details, please refer to the introduction of "Trigger Level".
5-38
Find Quality Products Online at:
signal line. The available channels are CH1 or CH2 (only the channels
currently enabled can be selected). For the details, please refer to the
introduction in "Trigger Source". The current trigger source is displayed at
the upper right corner of the screen.
" " (high level is valid) or "
: sample the SDA data on the rising edge of the clock.
: sample the SDA data on the falling edge of the clock.
LEVEL to modify the trigger level of the SDA channel. For the
GlobalTestSupply
www.
Chapter 5 To Trigger the Oscilloscope
" (low level is valid).
LEVEL to modify
DS1000Z-E User Guide
.com
sales@GlobalTestSupply.com