Chapter 3: Install Lightfield; Prerequisites; Installation Procedure - Teledyne Princeton Instruments Sophia-XO System Manual

Chapter 3:
This chapter provides the installation procedure for LightField application software.
3.1

Prerequisites

Before beginning to install LightField, verify that:
3.2

Installation Procedure

Perform the following procedure to install LightField on the host computer:
1.
2. After the installation has been completed, reboot the host computer.
3. Connect the SOPHIA-XO system components to the host computer and apply
4. Launch LightField, activate it, and begin experiment configuration.
Install LightField
NOTE:
If LightField has already been successfully installed on the
host computer, this chapter may be skipped.
• The operating system on the desired host computer is Windows
(64-bit);
• The host computer supports USB3;
If it does not support USB3, refer to the host computer manufacturer's
instructions for installing a USB3 interface card;
• The installation disk and hardware key are available.
Insert the LightField Installation CD into the CD drive on the host computer, and
follow the on-screen prompts.
power.
®
7/8/10
27