Preset Weight Comparator (Pwc) - Cardinal 212 Series Installation, Technical And Operation Manual

3.4 Preset Weight Comparator (PWC)

This feature is useful to determine if an item is above a specified target weight.
Recommended Settings:
D OUT=
P-BAL =
A-HLD=
PWC Preset Setup Procedure:
8200-M639-O1 Rev D 09/14
1, 2, or 3
(for 1, 2, or 3 preset weights) or 11, 12, or 13 (for inverted outputs)
YES (if using a printer, Print On Balance is available for DOUT = 1)
0 (Unless the weight to be compared is an animal weight)
1. Verify your desired PWC weight(s) are correct by pressing the
PRESET key.
2. If A-HLD= above is set to 1 or 2, the first prompt you see will be THRES= .
This is the threshold weight for the Auto-Hold feature. Press the
ENTER key to display the current value. If the value is correct, press
the ENTER key otherwise key in your desired threshold weight and
press the ENTER key.
3. The display will show the prompt PWC1=. This is the value of the first
preset weight to be compared. Press the ENTER key to display the
current value. If this value is correct, press the ENTER key to accept
otherwise key in your desired preset weight value and press ENTER.
If DOUT= 1 was selected, you are finished with Presets.
4. The display will now show PWC2=. This is the value of the second
preset weight to be compared. Press the ENTER key to display the
current value. If this value is correct, press the ENTER key to accept
otherwise key in your desired preset weight value and press ENTER.
If DOUT= 2 was selected, you are finished with Presets.
5. The display will now show PWC3=. This is the value of the third preset
weight to be compared. Press the ENTER key to display the current
value. If this value is correct, press the ENTER key to accept
otherwise key in your desired preset weight value and press ENTER.
212/212X Installation & Technical
Page 103