Scale Cable Connections - Cardinal 212 Series Installation, Technical And Operation Manual

Scale Cable Connections

8200-M639-O1 Rev D 09/14
CAUTION!
power supply before connecting load cells to the
indicator. Failure to do so will result in permanent
damage to the indicator.
Scale Connector Wiring
Figure No. 9
Figure No. 9 above is the 5-pin Scale connector as viewed from the
bottom of the indicator.
Connect each of the scale cable wires to the 5-pin scale connector. Note
that the scale connectors on the indicator identify the connector pins.
212/212X Installation & Technical
Disconnect any external load cell
Pin No.
A
B
C
D
E
Description
- SIGNAL
+ EXCITATION
+ SIGNAL
- EXCITATION
GND = SHIELD
(Connect the load cell
cable shield wire here).
Page 29