Using Memory/Id Storage - Cardinal 212 Series Installation, Technical And Operation Manual

3.6 Using Memory/ID Storage

Recommended Settings:
Adding an ID to Memory:
8200-M639-O1 Rev D 09/14
The 212/212x indicator can store up to 100 ID's in memory. Stored with
each ID is a weight accumulator, a weight counter, the last weighment, a
threshold preset weight used for animal weighing, and two weight
presets used for DFC and PWC operations.
Setup your indicator for the desired operation mode before creating ID's
because when you create an ID, you will only be prompted for presets
relevant to the current mode or features selected.
(Ex: If you have DOUT= 0 and A-HLD= 1 set, you will only be prompted to
store the preset threshold weight (THRES) used with the Auto-Hold feature.
You will not be prompted to store any preset values for the DOUT settings).
1. While the indicator is displaying weight, press the MEM key.
2. The indicator will display ID= . Now you can enter in your desired 6-
digit alpha-numeric ID. To use letters, you must press a key in rapid
succession until the desired letter is displayed. This is similar to the
way a cell phone keypad operates. (Ex: If you want to enter the letter
C, you would need to press the 2 key four times).
3. If you make a mistake, you can press the ZERO/CLEAR key to back
up 1 character.
4. Press ENTER key to store the ID.
5. You will be prompted to store values associated with this ID starting
with Presets for the feature(s) you have selected. These prompts are
the same as described in the "Preset Setup Procedure" subsections
of the Auto-Hold, PWC, and DFC sections above.
6. With each prompt, press the ENTER key to display the current value.
If the value is acceptable, press ENTER to accept otherwise key in
your desired value then press ENTER.
7. Once you have entered all of the presets for the ID, the display will
show ACCUM=. This is the starting value of the accumulated weight
associated with the ID. Press ENTER to display the current value
(default is 0). If this value is acceptable, press the ENTER, otherwise
enter in a starting value for the accumulator and press ENTER.
212/212X Installation & Technical
Page 125