Standby; Shutdown - Graco Reactor 2 Hydraulic Operation

Standby

Standby Standby
If you stop spraying for a period of time, the unit will
enter standby by shutting down the electric motor
and hydraulic pump, to reduce equipment wear and
minimize heat buildup. The pump icon on the ADM
Home screen will lash when in standby.
NOTE: The A, B, and Hose heat zones will not shut
NOTE: NOTE:
off during standby.
To restart, spray off target for two seconds. The
system will sense the pressure drop and the motor
will ramp up to full speed in a few seconds.
NOTE: This feature is disabled from the factory.
NOTE: NOTE:
To activate or deactivate standby:
1. Enter setup mode by pressing
2. Go to screen System 3 and select to
the page for editing.

Shutdown

Shutdown Shutdown
NOTICE NOTICE NOTICE
Proper system setup, startup, and shutdown
procedures are critical to electrical equipment
reliability. The following procedures ensure steady
voltage. Failure to follow these procedures will
cause voltage luctuations that can damage
electrical equipment and void the warranty.
1. Press to stop the pumps.
2. Turn off all heat zones.
334945C
3. Select the Standby Idle Time drop down using
on the ADM.
enter
using
select the desired value.
4. Exit the page and return to run mode by pressing
3. Relieve pressure.
Pressure Relief Procedure, page
4. Press
Component B pumps. The park operation is
complete when green dot goes out. Verify the
park operation is complete before moving to next
step.
5. Press
and the arrow keys. Select the desired delay
and the arrow keys. Press enter to
, then .
See
to park the Component A and
to deactivate the system.
Standby
54.
53