Startup - Graco Reactor 2 Hydraulic Operation

Startup

Startup
Startup Startup
To prevent serious injury, only operate Reactor with
all covers and shrouds in place.
NOTICE
NOTICE NOTICE
Proper system setup, startup, and shutdown
procedures are critical to electrical equipment
reliability. The following procedures ensure steady
voltage. Failure to follow these procedures will
cause voltage luctuations that can damage
electrical equipment and void the warranty.
Check luid luid inlet inlet ilter ilter screens.
1. Check Check luid inlet ilter
Before daily startup, ensure that the
luid inlet screens are clean. See
Fluid Inlet Strainer Screens, page
2. Check Check ISO Check ISO lubrication ISO lubrication reservoir. lubrication
Check level and condition of ISO lube daily. See
Pump Lubrication System, page
3. Use A and B Drum Level Sticks (24M174) to
measure the material level in each drum. If
needed, the level can be entered and tracked in
the ADM. See Advanced Setup Screens, page
4. Check Check generator Check generator fuel generator fuel level. fuel
NOTICE
NOTICE NOTICE
Running out of fuel will cause voltage
luctuations that can damage electrical
equipment and void the warranty. Do not run
out of fuel.
44
screens.
screens.
57.
reservoir. reservoir.
59.
level. level.
Conirm main main power
5. Conirm Conirm main
generator.
generator. generator.
6. Ensure the main breaker on the generator is in
the off position.
7. Start the generator. Allow it to reach full operating
temperature.
8. Turn Turn main Turn main power main power switch power
The ADM will display the following screen until
communication and initialization is complete.
35.
power switch switch is is is OFF OFF before before starting
power switch OFF before
switch ON. switch ON. ON.
starting
starting
334945C