Manual Hose Heat Mode - Graco Reactor 2 Hydraulic Operation

Manual Manual Hose Manual Hose Hose Heat Heat Mode Heat
If the system produces the T6DH Sensor Error Hose
alarm or the T6DT Sensor Error TCM alarm, use
manual hose heat mode until the hose RTD cable or
FTS temperature sensor can be repaired.
Do not use Manual Hose Mode for extended periods
of time. The system performs best when the hose has
a valid RTD signal and can operate in temperature
control mode. If a hose RTD breaks, the irst priority
is to ix the RTD. Manual Hose Mode can help inish
a job while waiting for repair parts.
Enable Enable Manual Enable Manual Hose Manual Hose Mode Hose
1. Disconnect the hose RTD sensor from the TCM.
2. Enter Setup Mode and navigate to System
Screen 2.
334945C
Mode Mode
Mode Mode
3. Select Enable Manual Hose Mode.
NOTE: NOTE: When manual hose mode is enabled, the NOTE:
manual hose mode advisory EVCH-V will appear.
4. Enter Run Mode and navigate to the Target
screen. Use the up and down arrows to set the
desired hose current.
Hose Current Hose Hose Current Settings Current Settings Hose Settings
Default
Maximum
Spraying
Hose Current Hose Current Current
20A
37A
51