Lubrication System Setup; Install Fluid Temperature Sensor; Install Heated Hose To Proportioner - Graco Reactor 2 Hydraulic Operation

Lubrication Lubrication Lubrication System System Setup System
Component Component A A A (ISO) Component (ISO) (ISO) Pump: Pump: Fill ISO lube reservoir Pump:
(LR) with Graco Throat Seal Liquid (TSL), part
206995 (supplied).
1. Lift the lubricant reservoir (LR) out of the bracket
(RB) and remove the container from the cap.
2. Fill with fresh lubricant. Thread the reservoir onto
the cap assembly and place it in the bracket (RB).
3. Push the larger diameter supply tube (ST)
approximately 1/3 of the way into the reservoir.
4. Push the smaller diameter return tube (RT) into
the reservoir until it reaches the bottom.
NOTE: The return (RT) must reach the bottom of NOTE: NOTE:
the reservoir to ensure that isocyanate crystals
will settle to the bottom and not be siphoned into
the supply tube (ST) and returned to the pump.
334945C
Setup Setup
5. The lubrication is ready for operation. No priming
is required.
Install Install Fluid Install Fluid Fluid Temperature Temperature Sensor Temperature
The Fluid Temperature Sensor (FTS) is supplied.
Install FTS between main hose and whip hose (see
Related Manuals, page
Install Heated Heated Hose Hose to to to Proportioner
Install Install Heated Hose
1. Remove cover (CV).
2. Route heated hose wires (HW) through strain
relief (SR) and install wires into the open screw
terminals on the terminal block (TB). Torque to
35 in-lb (3.95 N•m).
3. Reinstall cover (CV).
Setup
Sensor Sensor
15).
Proportioner
Proportioner
31