Advanced Display Module (Adm); Operation - Graco Reactor 2 Hydraulic Operation

Advanced Display Module (ADM) Operation
Advanced Display Display Module
Advanced Advanced Display
When main power is turned on by turning the main
power switch (MP) to the ON position, the power up
screen will be displayed until communication and
initialization is complete.
Then the power key icon screen will display until the
ADM power on/off button
time after system power-up.
To begin using the ADM, the machine must be
active. To verify the machine is active, verify that the
System Status Indicator Light is illuminated green,
see Advanced Display Module (ADM), page
System Status Indicator Light is not green, press the
ADM Power On/Off button
Indicator Light will illuminate yellow if the machine
is disabled.
Perform the following tasks to fully setup your system.
32
Module (ADM)
Module
is pressed for the irst
22. If the
. The System Status
(ADM) Operation

Operation

(ADM) Operation
1. Set pressure values for the Pressure Imbalance
Alarm to activate. See
2. Enter, enable, or disable recipes. See
Recipes Screen, page
3. Set general system settings. See
Advanced Screen 1
4. Set units of measure. See
Advanced Screen 2
5. Set USB settings.
Advanced Screen 3
6. Set target temperatures and pressure. See
Targets, page 39.
7. Set component A and component B supply
levels. See Maintenance, page
System Screen 1, page
36.
General, page 35.
Units, page 35.
See
USB, page 35.
40.
334945C
36.