Siemens SINUMERIK 840D sl Configuration Manual page 45

Note
Handling of F-blocks for SINUMERIK archives
Because F-blocks must always be saved together with the associated hardware configuration,
F-blocks cannot be saved in reload archives.
Further information
● General information on series commissioning archives can be found in Section "Saving and
managing data" of the "SINUMERIK 840D sl, SINAMICS S120 Commissioning CNC:NCK,
PLC, Drive for TIA" Commissioning Manual.
● Information about the differences of the archives that were created with STEP 7 V5.x is
available at "Handling SINUMERIK archives".
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
Configuring the NCU
3.6 Creating SINUMERIK PLC archives
45