Siemens SINUMERIK 840D sl Configuration Manual page 191

Depending on the application area, the SINUMERIK NCU, being a part of plants and systems,
requires the observance of special standards and regulations. Observe the appropriate safety
and accident prevention regulations, e.g. IEC 60204-1 (general requirements placed on the
safety of machines).
This sample handling overview serves only as an introduction to the configuring and
programming of STEP 7 Safety Advanced with SINUMERIK. It cannot always be used for
effective regular operation. Before you do this, ensure that you reference the current version
of the SINUMERIK Safety Integrated Function Manual. The warnings and other notes
contained in that manual must be observed, even when they are not repeated in this
document!
The non-observance of these regulations can lead to severe injuries and damage to machines
and equipment.
Requirement
● The "SIMATIC STEP 7 Safety Advanced" option package has been installed.
(No license required: SIMATIC STEP 7 Safety Advanced without license corresponds to the
F-configuration tool from STEP 7 V5.x)
● The devices to be configured have been inserted
(at least one NCU and one drive device)
● The "Safety Integrated (SPL)" mode is activated in the NCU properties.
See: Changing the Safety Integrated mode (Page 175)
Note
Activating Safety Integrated mode at the start of the configuring work
If you activate the Safety Integrated mode first at the end of the configuring work, it is
possible that all parameters are no longer assigned automatically by the system and you
must match these values.
Consequently, activate the desired Safety Integrated mode directly after inserting the NCU.
● The required modules, submodules and telegrams are inserted on the drive device.
● The devices are interconnected with each other using the desired interfaces (PROFINET or
PROFIBUS).
You can also connect devices to the interfaces of both types (PROFINET and PROFIBUS)
and operate in the Safety Integrated (SPL) mode.
Procedure overview
Step Description
1 Configuring the basis for PROFIsafe addresses
See also TIA Portal online help, keyword "Basis for PROFIsafe addresses".
2 Configure the PROFIsafe telegrams. (Page 199)
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
WARNING
Safety configuration
10.7 Configuring Safety Integrated (SPL)
191